Diagnostic Procedure

WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

DTC U3003:17 (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	CONFIRM PCM DTC Perform the PCM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [LF, L5] .) (See ON-BOARD DIAGNOSTIC TEST [L3 WITH TC] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [LF, L5] .) (See DTC TABLE [L3 WITH TC] .)
1		No	Go to the next step.
2	INSPECT GENERATOR Inspect the generator. (See GENERATOR INSPECTION [LF, L5] .) (See GENERATOR INSPECTION [L3 WITH TC] .) Is there any malfunction?	Yes	Replace the generator, then go to the next step. (See GENERATOR REMOVAL/INSTALLATION [LF, L5] .) (See GENERATOR REMOVAL/INSTALLATION [L3 WITH TC] .)
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING COMPLETED Operate the advanced key to activate the keyless control module. Clear the DTC from the keyless control module using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Operate the advanced key to activate the keyless control module. Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Is the same DTC present?	Yes	Replace the keyless control module, then go to the next step. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
4		No	DTC troubleshooting completed.