Neutral Switch Inspection
WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
- Disconnect the negative battery cable.
- Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .) (See NEUTRAL SWITCH REMOVAL/INSTALLATION .) (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
- Inspect for continuity between the neutral switch terminals using an ohmmeter.
- If not as specified, replace the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .) (See NEUTRAL SWITCH REMOVAL/INSTALLATION .) (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
Specification
CONTINUITY CHART
| Measured condition | Continuity |
|---|---|
| Rod pushed | Continuity detected |
| Except above | No continuity |