Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> CX-9 Touring, 3.7 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 585 (Dynamic Stability Control System/Roll Stability Control System) >> DSC/RSC HU/Cm Removal/Installation >> Brake Pipe Installation Note

Brake Pipe Installation Note

WARNING: This page is about a different car, the 2009 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the marks made before removal and install the brake pipe to the DSC/RSC HU/CM and brake pipe joint referring to the figure.
  2. Tighten the brake pipe to the specified torque using the SST  (49 0259 770B) and the commercially available flare nut wrench.
    Fig 1: Identifying Master Cylinder (Primary Side & Secondary Side)
    G04970211Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals