Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle (Service, Removal & Installation G66M-R)) >> Manual Transaxle Removal/Installation [G66M-R] >> Manual Transaxle Removal Note

Manual Transaxle Removal Note

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Remove the transaxle carefully, holding it steady. If the transaxle falls it could be damaged or cause injury.
  1. Adjust the SST  and lean the engine toward the transaxle.
    Fig 1: Adjusting SST And Lean Engine Toward Transaxle
    G06205821Courtesy of MAZDA MOTORS CORP.
  2. Remove the bolt securing the brake hose to the bracket as shown in the figure, and disconnect brake hose from the bracket.
    Fig 2: Illustrating Bracket Bolt Removal/Installation
    G06205823Courtesy of MAZDA MOTORS CORP.
  3. Support the transaxle on a jack.
  4. Remove the transaxle mounting bolts.
  5. Remove the transaxle.
    Fig 3: Supporting Transaxle On Jack
    G06205824Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals