Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle (Service, Removal & Installation G66M-R)) >> Back-Up Light Switch Removal/Installation [G66M-R]

Back-Up Light Switch Removal/Installation [G66M-R]

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove the aerodynamic under cover No 2. See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .
  3. Drain the oil from the transaxle
  4. Disconnect the back-up light switch connector and remove the back-up light switch.
  5. Install in the reverse order of removal
  6. Add the specified amount and type of oil. See TRANSAXLE OIL REPLACEMENT [G66M-R] )
  7. Install the aerodynamic under cover No. 2. See AERODYNAMIC UNDER COVER NO 2 REMOVAL/INSTALLATION .
    Fig 1: Identifying Back-Up Light Switch Connector
    G06205810Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals