Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 6 s Touring Plus >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting [Engine MZI-3.7] >> Engine Control System Operation Inspection [MZI-3.7] >> Variable Valve Timing Control System Operation Inspection >> When idling cannot be continued

When idling cannot be continued

NOTE:
  • Inspect for each bank
  1. Remove the OCV and verify that the spool valve is at maximum retard position.
  2. Connect the OCV connector.
  3. Switch ignition to ON.
  4. Verify that the spool valve is at max. retard position.
    • If the spool valve is stuck in advance direction, inspect the following:
      • Short circuit in harnesses or connectors between the OCV and the PCM.
  5. Inspect the variable valve timing actuator.
scientia non olet · About Mike's Workshop Manuals