Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 6 s Touring Plus >> Repair and Diagnosis >> Brakes >> Traction Control >> Symptom Troubleshooting [Abs/TCS) >> Precaution [Abs/TCS] >> Intermittent Concern Troubleshooting >> Inspection Method For Sensors

Inspection Method For Sensors

  1. Connect the M-MDS to DLC-2
  2. Switch the ignition to ON (engine off).
    NOTE:
    • If engine starts and runs, perform the following steps at idle.
  3. Access the PIDs for the switch you are inspecting.
  4. Vibrate the sensor slightly with your finger
    • If the PID value is unstable or malfunction occurs, check for poor connection and/or poorly mounted sensor.
scientia non olet · About Mike's Workshop Manuals