Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle [Shift Mechanism] >> Selector Lever Component Inspection

Selector Lever Component Inspection

  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  2. Disconnect the negative battery cable.
  3. Remove the battery duct. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  4. Remove the following parts:
    1. Side wall.
    2. Heat insulator (front and center).
    3. Selector lever knob and indicator component.
    4. Center console. (See CENTER CONSOLE REMOVAL/INSTALLATION .)
  5. Disconnect the selector lever component connector.
  6. Verify that the continuity is as indicated in the table in illustration.
    • If there is any malfunction, replace the selector lever component. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)
      Fig 1: Continuity Chart
      G06761529Courtesy of MAZDA MOTORS CORP.
      Fig 2: Identifying Selector Lever Component Connector Terminals
      G05545230Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals