Diagnostic procedure

DTC P2088 [L3] DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA (MODE 12) HAS BEEN RECORDED Has FREEZE FRAME DATA (Mode 12) been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA (Mode 12) on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT OCV CONNECTOR FOR POOR CONNECTION Turn the ignition switch off. Inspect for poor connection (such as damaged, pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 9.
3		No	Go to the next step.
4	INSPECT OCV Inspect the OCV. (See OIL CONTROL VALVE (OCV) INSPECTION .) Is the OCV normal?	Yes	Go to the next step.
4		No	Replace the OCV, then go to Step 9.
5	INSPECT OCV POWER SUPPLY CIRCUIT FOR OPEN CIRCUIT Disconnect the OCV connector. Turn the ignition switch to the ON position (Engine off). Measure the voltage between variable tumble control solenoid valve terminal B (wiring-harness-side) and body ground. Is the voltage B+ ?	Yes	Go to the next step.
5		No	Repair or replace the wiring harness for open circuit, then go to Step 9.
6	INSPECT PCM CONNECTOR FOR POOR CONNECTION Turn the ignition switch off. Disconnect the PCM connector. Inspect for poor connection at PCM terminal 2E (such as damaged, pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair the terminal, then go to Step 9.
6		No	Go to the next step.
7	INSPECT OCV CONTROL CIRCUIT FOR SHORT TO GROUND Inspect for continuity between OCV terminal A (wiring-harness-side) and body ground. Is there continuity?	Yes	Repair or replace the wiring harness for short to ground, then go to Step 9.
7		No	Go to the next step.
8	INSPECT OCV CONTROL CIRCUIT FOR OPEN CIRCUIT Connect the OCV connector. Turn the ignition switch to the ON position (Engine off). Inspect for continuity between OCV terminal A (wiring-harness-side) and PCM terminal 2E (wiring-harness-side). Is there continuity?	Yes	Go to the next step.
8		No	Repair or replace the wiring harness for open or short circuit to ground, then go to the next step.
9	VERIFY TROUBLESHOOTING OF DTC P2088 COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE .) Perform the KOEO/KOER self test. (See KOEO/KOER SELF TEST .) Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
9		No	Go to the next step.
10	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .) Is there any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
10		No	Troubleshooting completed.