Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3] >> DTC P0507 >> Diagnostic procedure

Diagnostic procedure

DTC P0507 [L3] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA (MODE 12) HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA (Mode 12) been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA (Mode 12) on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to available repair information.
  • If vehicle is not repaired, then go to the next step.
No Go to the next step.
3 VERIFY RELATED PENDING OR STORED DTCS 
  • Turn the ignition switch off, then to the ON position (Engine off).
  • Verify PENDING CODE or stored DTCs using the M-MDS.
  • Is other DTC present?
 Yes Repair the applicable DTCs.
(See DTC TABLE .)
No Go to the next step.
4 INSPECT VACUUM HOSE CONNECTION 
 Yes Go to the next step.
No Reconnect vacuum hose accurately, then go to the next step.
5 VERIFY TROUBLESHOOTING OF DTC P0507 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Start the engine.
  • Clear the DTC from the PCM memory using the M-MDS.
  • Depress the brake pedal for 14.1 s or more. 
  • Is the PENDING CODE for this DTC present?
 Yes Replace this PCM, then go to the next step.
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE .)
No Troubleshooting completed.
scientia non olet · About Mike's Workshop Manuals