Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System [LF, L5]) >> Manifold Absolute Pressure (Map) Sensor Removal/Installation

Manifold Absolute Pressure (Map) Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  2. Disconnect the negative battery cable.
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  4. Disconnect the MAP sensor connector.
  5. Remove the MAP sensor.
  6. Install in the reverse order of removal.
Fig 1: Manifold Absolute Pressure (MAP) Sensor Replacement Components With Torque Specifications
G06730873Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals