Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2009 >> CX-7 Touring, 2.3 L, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Security System And Locks System) >> Trunk Lid Latch Switch Inspection

Trunk Lid Latch Switch Inspection

WARNING: This page is about a different car, the 2009 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the trunk lid trim. (See TRUNK LID TRIM REMOVAL/INSTALLATION .)
  3. Remove the trunk lid latch and release actuator. (See TRUNK LID LATCH AND RELEASE ACTUATOR REMOVAL/INSTALLATION .)
  4. Press the latch in using a flathead screwdriver to inspect the latch lever condition.
    Fig 1: View Of Trunk Lid Latch
    G00485706Courtesy of MAZDA MOTORS CORP.
  5. Verify that the continuity is as indicated in the table.
    • If not as indicated in the table, replace the trunk lid latch and release actuator.
    Fig 2: Trunk Lid Latch Switch Continuity Chart
    G04956874Courtesy of MAZDA MOTORS CORP.
    Fig 3: Identifying Trunk Lid Latch Switch Connector Terminals With Circuit Diagram
    G04956875Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals