Communications Network - Troubleshooting: Ms-Can: Notes

The MS-CAN uses an unshielded twisted pair cable of data (+) and data (-) circuits. The data (+) and the data (-) circuits are each regulated to approximately 2.5 volts during neutral or rested network traffic. As bus messages are sent on the data (+) circuit, voltage is increased by approximately 1.0 volt. Inversely, the data (-) circuit is reduced by approximately 1.0 volt when a bus message is sent. Multiple bus messages can be sent over the CAN circuits allowing multiple modules to communicate with each other. The MS-CAN is used for the IC and the smart junction box (SJB) communications, and is designed for general information transfer. The MS-CAN network will not communicate while certain faults are present, but will operate with diminished performance with other faults present. The MS-CAN bus may remain operational when 1 of the 2 termination resistors are not present.

The MS-CAN network operates at a maximum data transfer speed of 125 Kbps for bus messages and is designed for general information transfer. The network will remain operational, but at a degraded level when certain circuit faults are present.

The following fault chart describes the specific MS-CAN network failures and their resulting symptom: