Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2008 >> Tribute s Touring, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System - Hybrid) >> Powertrain Control Module (Pcm) - 3.0L (4V) Removal/Installation >> Installation

Powertrain Control Module (Pcm) - 3.0L (4V) Removal/Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the PCM and the 2 stud bolts.
    • To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
  2. Connect the 3 PCM electrical connectors.
  3. Position the manifold absolute pressure (MAP) sensor and the wiring harness and install the 2 PCM stud bolt nuts.
    • To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. See PROGRAMMABLE MODULE INSTALLATION (PMI) .
  5. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. See KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
scientia non olet · About Mike's Workshop Manuals