Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2008 >> 6 s Touring, 4D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 657 (Security System And Locks System) >> Request Switch Removal/Installation[With Advanced Keyless System] >> Trunk Lid

Trunk Lid

WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the rear bumper. (see REAR BUMPER REMOVAL/INSTALLATION .)
  3. Detach the request switch from the rear bumper.
  4. Install in the reverse order of removal.
Fig 1: Identifying Request Switch, Connector, Rear Bumper & Tab
G04928916Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals