PID/Data Monitor Inspection [Advanced Keyless System]

Connect the M-MDS to the DLC-2 connector.

Fig 1: Identifying DLC-2 Connector (16-Pin)
Courtesy of MAZDA MOTORS CORP.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
  - Select the "Toolbox" tab.
  - Select "DataLogger".
  - Select "Modules".
  - Select "RKE".
- When using the PDS (Pocket PC)
  - Select "Module Tests".
  - Select "Optional" Tab.
  - Select "RKE".
  - Select "DataLogger".
Select the applicable PID from the PID table.
Verify the PID data according to the directions on the screen.

NOTE: The PID data screen function is used for monitoring the calculated value. Therefore, if the monitored value of the output parts is not within specification, inspection of the monitored value of input parts corresponding to applicable output part control is necessary. In addition, because the system does not display output part malfunction as abnormality in the monitored value, it is necessary to inspect the output part individually.