M-MDS Execution Menu/Sequence For The Immobilizer System Component Parts Replacement: Notes
NOTE:
- When the component parts of the immobilizer system are replaced, the menu and execution sequence of the M-MDS vary depending on the type of the replaced unit and parts. Perform the procedures referring to the following table.
- When performing the procedure, follow each procedure. If the procedure is not followed, the procedure may not be completed correctly.
- NO.1 ADDITIONAL KEY PROGRAMMING PROCEDURE (USING TWO VALID KEYS)
- NO. 2 KEY ADDITIONAL PROGRAMMING PROCEDURE (USING THE M-MDS)
- NO.3 KEY REPLACEMENT PROCEDURE (CLEARING PREVIOUSLY PROGRAMMED KEY ID NUMBERS, KEY RE-PROGRAM)
- NO.4 PCM REPLACEMENT PROCEDURE
- NO. 5 KEY ADDITIONAL PROGRAMMING PROCEDURE CHANGING
- NO.6 STEERING LOCK UNIT REPLACEMENT PROCEDURE
- NO.7 KEYLESS CONTROL MODULE REPLACEMENT PROCEDURE
- NO.8 THE PROCEDURE FOR WHEN SEVERAL PARTS (PCM, KEYLESS CONTROL MODULE, AND STEERING LOCK UNIT) ARE REPLACED AT THE SAME TIME