Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> CX-7 Touring, AWD >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC) - (3 Of 4) >> DTC P0602 >> Notes

DTC P0602: Notes

DTC P0602[L3 WITH TC] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0602 PCM programming error
DETECTION CONDITION 
  • No configuration data in PCM
    NOTE:
    • If the "PCM CONFIGURATION" is successful, the PCM stores DTC P0602 and illuminates the MIL (System is normal). Clear DTC P0602 using the M-MDS after the "PCM CONFIGURATION".
    • MIL turns off after three drive cycles with no failure (DTCs remain in PCM).

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTCs are stored in PCM memory.
POSSIBLE CAUSE 
  • Configuration has not been completed.
  • PCM malfunction
scientia non olet · About Mike's Workshop Manuals