Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> CX-7 Touring, AWD >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC) - (3 Of 4) >> DTC P0222 >> Notes

DTC P0222: Notes

DTC P0222[L3 WITH TC] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0222 TP sensor N6.2 circuit low input
DETECTION CONDITION 
  • If PCM detects that the TP sensor NO. 2 voltage is below 0.2 V  after the ignition switch to the ON position, the PCM determines that TP circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTCs are stored in the PCM memory.
POSSIBLE CAUSE 
  • TP sensor malfunction
  • Connector or terminal malfunction
  • Open circuit between throttle body terminal C and PCM terminal 2AL
  • Short to ground between throttle body terminal C and PCM terminal 2AL
  • Open circuit between throttle body terminal B and PCM terminal 2AO
  • Short to ground between throttle body terminal B and PCM terminal 2AO
  • PCM malfunction
G04859385Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals