Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> B3000 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Crankshaft Position (CKP) Sensor Removal / Installation - 4.0L >> Removal and Installation

Removal and Installation

Fig 1: Crankshaft Position Sensor, Bolt And Electrical Connector With Torque Specifications
G04930188Courtesy of MAZDA MOTORS CORP.
  1. Remove the crankshaft position (CKP) sensor.
    1. Disconnect the electrical connector.
    2. Remove the bolts.
    3. Remove the sensor.
    NOTE:
    • The new CKP sensor must be touching the damper. The new sensor has wear tabs that will wear off after several engine revolutions.
  2. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals