Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 6 s, 4D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (On-Board Diagnostic [Engine Control System L3 With TC]) >> On-Board Diagnostic Test >> Pending Trouble Code Access Procedure

Pending Trouble Code Access Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Self Test".
      3. Select "Modules".
      4. Select "PCM".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "PCM".
      3. Select "Self Test".
  3. Then, select the "Retrieve CMDTCs" and perform procedures according to directions on the M-MDS screen.
    Fig 1: Locating DLC-2 Connector
    G04324072Courtesy of MAZDA MOTORS CORP.
  4. Retrieve the pending trouble codes according to the directions on the M-MDS screen.
scientia non olet · About Mike's Workshop Manuals