Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 6 s, 4D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 582 (Power Steering System) >> Steering Gear And Linkage Removal/Installation >> Notes

Steering Gear And Linkage Removal/Installation: Notes

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
  1. Remove the ABS wheel-speed sensor. (See FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION .)
  2. Remove the front stabilizer. (See FRONT STABILIZER REMOVAL/INSTALLATION .)
  3. Remove in the order indicated in Fig 1.
  4. Install in the reverse order of removal.
  5. After installation, adjust the total toe-in. (See FRONT WHEEL ALIGNMENT .)
    Fig 1: View Of Steering Gear And Linkage Components With Torque Specifications
    G04318779Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals