Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (On-Board Diagnostic [Engine Control System (AJ]) >> On-Board Diagnostic Test >> Freeze Frame PID Data Access Procedure

Freeze Frame PID Data Access Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Self Test".
      3. Select "Modules".
      4. Select "PCM"
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "PCM".
      3. Select "Self Test".
  3. Then, select the "Retrieve CMDTCs" and perform procedures according to directions on the M-MDS screen.
    Fig 1: Locating DLC-2 Connector
    G04324291Courtesy of MAZDA MOTORS CORP.
  4. Retrieve the freeze frame PID data according to the directions on the M-MDS screen.
scientia non olet · About Mike's Workshop Manuals