Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Fuel System (L3, AJ)) >> Fuel Injector Removal/Installation [L3] >> Notes

Fuel Injector Removal/Installation [L3]: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.
  1. Complete the "BEFORE REPAIR PROCEDURE". See BEFORE REPAIR PROCEDURE .
  2. Disconnect the negative battery cable.
  3. Remove in the order indicated in the table.
    Fig 1: Fuel Injectors & Torque Specification
    G04324821Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
  5. Complete the "AFTER REPAIR PROCEDURE".

    See AFTER REPAIR PROCEDURE .

scientia non olet · About Mike's Workshop Manuals