Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Engine Control System (L3 With TC)) >> Camshaft Position (CMP) Sensor Inspection >> Visual Inspection

Visual Inspection

WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover.
  2. Disconnect the negative battery cable.
  3. Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION ).
  4. Verify that there are no metal shavings on the sensor.
    • If the monitor item condition/specification (reference) is not within the specification even though there is no malfunction, carry out the "Circuit Open/Short Inspection".
scientia non olet · About Mike's Workshop Manuals