Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Brakes >> Traction Control >> On-Board Diagnostic (Abs/TCS) >> Abs/TCS On-Board Diagnosis >> Active Command Modes Procedure

Active Command Modes Procedure

NOTE:
  • When driving, the ABS motor and each valve automatically turn ABS_POWER on, and then each command on. ABS_POWER regulates the power supply for the ABS motor and 8 valves.
  1. Connect M-MDS to the vehicle DLC-2 connector.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Datalogger".
      3. Select "Modules".
      4. Select "ABS".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "ABS/TCS".
      3. Select "Datalogger".
  3. Select the active command modes from the PID table.
    Fig 1: Locating DLC-2 Connector
    G04325977Courtesy of MAZDA MOTORS CORP.
  4. Perform active command modes, inspect the operations for each part.
    • If there is no operation sound from the relay, motor, and solenoid after the active command mode inspection is performed, it is possible that there is an open or short circuit in the wiring harness, relay, motor or solenoid, or sticking and operation malfunction.
scientia non olet · About Mike's Workshop Manuals