Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 5 Touring, 2.3 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System [Engine (L3)]) >> Accelerator Pedal Position (App) Sensor Inspection >> Notes

Accelerator Pedal Position (App) Sensor Inspection: Notes

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Before performing the following inspection, make sure to follow the troubleshooting flowchart. (See FOREWORD ).
  1. Connect the M-MDS or equivalent to the DLC-2.
  2. Turn the ignition switch to ON position.
  3. Select APP1 and APP2 PID on the M-MDS or equivalent.
  4. Verify that the APP1 and APP2 PID is within the specification when the accelerator pedal not depressed. (See PCM INSPECTION ).
    Fig 1: Locating DLC-2 Connector
    G04315948Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals