PID/Data Monitor Inspection (Immobilizer System - Keyless Entry System): Notes

NOTE: The PID/Data monitor function is used for monitoring the calculated value. Therefore, if the monitored value of the output parts is not within the specification, inspection of the monitored value of input parts corresponding to applicable output part control is necessary. In addition,. because the system does not display output part malfunction as abnormality in the monitored value, it is necessary to inspect the output part individually.

Connect the M-MDS or equivalent to the DLC-2.

Fig 1: Identifying Data Link Connector (DLC-2)
Courtesy of MAZDA MOTORS CORP.
After the vehicle is identified, from the initial screen select the following items:
- When using the IDS (laptop PC)
  1. Select the "Tool Box" tab
  2. Select "DataLogger"
  3. Select "Modules"
  4. Select "RKE"
- When using the PDS (Pocket PC)
  1. Select "Module tests"
  2. Select "RKE"
  3. Select "DataLogger"
Select the applicable PID from the PID table.
Verify the PID data according to the directions on the screen.