Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 3 i, 2.0 F, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System (L3 With TC)) >> Neutral Switch Inspection >> Continuity Inspection

Continuity Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
  2. Verify that the continuity between neutral switch terminals A and B is as indicated in the table.
    • If it can be verified, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
    • If it cannot be verified, replace the neutral switch.
      Fig 1: Identifying Neutral Switch Connector Terminals
      G04955310Courtesy of MAZDA MOTORS CORP.
    CONTINUITY REFERENCE

    Measured condition Continuity
    Rod pushed Continuity detected
    Except above No continuity
scientia non olet · About Mike's Workshop Manuals