DTC P0327: Notes
DTC P0327 (LF, L3) DETECTION CONDITION AND POSSIBLE CAUSES
| DTC P0327 |
KS circuit low input |
| DETECTION CONDITION |
- The PCM monitors input signal from the KS when the engine is running. If the input voltage between PCM terminals for the KS circuit is below 0.01 V , below 0.06 V
the PCM determines that the KS circuit has malfunction.
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition during first drive cycle.
- PENDING CODE is available if the PCM detects the above malfunction condition.
- FREEZE FRAME DATA is available.
- DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- KS malfunction
- Connector or terminal malfunction
- Open circuit or short to ground in wiring harness between KS connector terminal A and PCM terminal 2U, 2Q
- Open circuit or short to ground in wiring harness between KS connector terminal B and PCM terminal 2V, 2R
- Short KS two wires
- PCM malfunction
|
 Courtesy of MAZDA MOTORS CORP.
|