Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 3 Mazdaspeed, 2.3 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Cruise Control System (LF, L3)) >> Cruise Control Switch Inspection [LF, L3] >> Notes

Cruise Control Switch Inspection [LF, L3]: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover.
  2. Disconnect the negative battery cable.
  3. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .)
  4. Disconnect the audio control switch connector.
  5. Inspect for resistance and continuity between cruise control switch terminals A-B using a tester.
    • If not as specified, replace the cruise control switch. (See AUDIO CONTROL SWITCH REMOVAL/INSTALLATION .)
      RESISTANCE SPECIFICATION

      Switch condition Resistance (ohm)
      ON/OFF button pressed Continuity
      CANCEL button pressed 118-122
      SET/COAST button pressed 667-693
      RES/ACCEL button pressed 2,156-2,244
      No button pressed No continuity
      Fig 1: Identifying Cruise Control Switch Connector Terminals
      G04955176Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals