Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2007 >> 3 Mazdaspeed, 2.3 L >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic (Engine Control System L3 With TC) - (4 Of 5) >> DTC P0607 >> Diagnostic procedure

Diagnostic procedure

DTC P0607 [L3 WITH TC] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED SERVICE BULLETINS AVAILABILITY 
  • Verify related Service Bulletins availability.
  • Is any related Service Bulletins available?
 Yes Perform the repair or diagnosis according to the available Service Bulletins.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY TROUBLESHOOTING OF P0607 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the M-MDS.
  • Start engine.
  • Is same DTC present?
 Yes Replace PCM, go to the next step.
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.
scientia non olet · About Mike's Workshop Manuals