Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2006 >> MX-5 Miata Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Symptom Troubleshooting [Abs] >> Precaution >> Intermittent Concern Troubleshooting >> Inspection Method For Sensors

Inspection Method For Sensors

  1. Connect the WDS or equivalent to DLC-2.
  2. Turn the ignition switch to the ON position (engine off).
    NOTE:
    • If engine starts and runs, perform the following steps at idle.
  3. Access PIDs for the switch you are inspecting.
  4. Vibrate the sensor slightly with your finger.
    • If the PID value is unstable or a malfunction occurs, inspect for poor connection and/or poorly mounted sensor.
scientia non olet · About Mike's Workshop Manuals