Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2006 >> MX-5 Miata Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Symptom Troubleshooting [Abs] >> Precaution >> Intermittent Concern Troubleshooting >> Inspection Method For Sensor Connectors Or Wires

Inspection Method For Sensor Connectors Or Wires

  1. Connect the WDS or equivalent to the DLC-2.
  2. Turn the ignition switch to the ON position (engine off).
    NOTE:
    • If the engine starts and runs, perform the following steps at idle.
  3. Access PIDs for the switch you are inspecting.
  4. Slightly shake each connector or wiring harness vertically and horizontally while monitoring the PID.
    • If the PID value is unstable, inspect for poor connection.
    Fig 1: Inspecting For Poor Connection By Shaking Connector
    G04318345Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals