Diagnostic Procedure

DTC U0236 DIAGNOSTIC PROCEDURE TABLE

STEP	INSPECTION		ACTION
1	INSPECT COMMUNICATION CIRCUIT FOR CONTINUITY Disconnect keyless control module connector and steering lock unit connector. Is there continuity between keyless control module terminal 3P and steering lock unit terminal G?	Yes	Replace the steering lock unit and perform the resetting procedure for the steering lock unit. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .) (See STEERING LOCK UNIT ID CODE REGISTRATION [WITH ADVANCED KEYLESS SYSTEM] .) Go to the next step.
1		No	Repair the wiring harness between the steering lock unit and keyless control module. Go to next step.
2	INSPECT KEYLESS CONTROL MODULE Turn the ignition switch to the ON position. Is the DTC displayed? WDS or equivalent: U0236	Yes	Replace the keyless control module and perform the resetting procedure for the advanced keyless system when replacing the keyless control module. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION .) (See CARD KEY ID CODE REGISTRATION [WITH ADVANCED KEYLESS SYSTEM] .) (See STEERING LOCK UNIT ID CODE REGISTRATION [WITH ADVANCED KEYLESS SYSTEM] .) (See KEYLESS CONTROL MODULE CONFIGULATION [WITH ADVANCED KEYLESS SYSTEM] .) (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [WITH ADVANCED KEYLESS SYSTEM] .) (See SECURITY ACCESS PROCEDURE .)
2		No	DTC troubleshooting completed.