Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2006 >> 6 s, 4D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (On-Board Diagnostic [Engine Control System L3 With TC)) >> After Repair Procedure

After Repair Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the WDS or equivalent.
  2. Cycle the ignition switch from the off to the ON position.
  3. Any retrieved DTCs.
  4. Clear all diagnostic data using the WDS or equivalent.
    Fig 1: Locating DLC-2 Connector
    G04324072Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals