Continuity Inspection

WARNING: This page is about a different variant/trim than selected.

Inspect the following if the power steering is inoperative (See POWER STEERING FLUID INSPECTION ).
- Power steering fluid level
- Power steering fluid leakage
- Power steering fluid pressure
Disconnect the PSP switch connector.
Start the engine.
Inspect for continuity between the PSP switch terminal and ground using a tester.
- If not as specified, replace the PSP switch. (See POWER STEERING OIL PUMP REMOVAL/INSTALLATION [L3, L3 WITH TC] ).
- If the PSP switch is normal, but PID value is out of specification, perform the "Circuit Open/Short Inspection".

Specification

Fig 1: Terminals Continuity Table

Courtesy of MAZDA MOTORS CORP.