Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2006 >> 6 s, 4D Hatchback, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System AJ] >> DTC P2402 >> Diagnostic procedure

Diagnostic procedure

DTC P2402 [AJ] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnostic according to the available repair information.
  • If the vehicle is not repaired, then go to the next step.
No Go to the next step.
3 VERIFY RELATED PENDING CODE OR STORED DTCs 
  • Turn ignition switch to OFF then ON (Engine off).
  • Verify related pending code or stored DTCs.
  • Are other DTCs present?
 Yes Go to appropriate DTC inspection.
(See DTC TABLE ).
No Go to the next step.
4 INSPECT EVAP SYSTEM LEAK DETECTION PUMP CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect the EVAP system leak detection pump connector.
  • Check for poor connection (such as damaged, pulled-out pins, and corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to Step 7.
No Go to the next step.
5 INSPECT EVAP SYSTEM LEAK DETECTION PUMP SIGNAL CIRCUIT FOR SHORT TO POWER 
  • Turn the ignition switch to the ON position.
  • Measure voltage between EVAP system leak detection pump terminal D and body ground.
  • Is voltage reading?
 Yes Repair or replace harness for short to power, then go to Step 7.
No Go to the next step.
6 INSPECT PCM CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect PCM connector.
  • Check for poor connection (such as damaged, pulled-out pins, and corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to the next step.
No Go to the next step.
7 VERIFY TROUBLESHOOTING OF DTC P2402 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear DTC from PCM memory using WDS or equivalent.
  • Perform the KOER SELF TEST using the WDS or equivalent.

    (See KOEO/KOER SELF TEST ).

  • Is the PENDING CODE same DTC present?
 Yes Replace PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
8 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.
scientia non olet · About Mike's Workshop Manuals