Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2005 >> MX-5 Miata Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting [Engine Control System BP, BP With TC) >> Intermittent Concern Troubleshooting >> Inspection Method for Sensor Connectors or Wires

Inspection Method for Sensor Connectors or Wires

  1. Connect WDS or equivalent to DLC-2.
  2. Turn the ignition switch to the ON position (Engine off).
    NOTE:
    • If engine starts and runs, perform the following steps while idling engine.
  3. Access PIDs for the switch you are inspecting.
  4. Shake each connector or wiring harness a bit vertically and horizontally while monitoring the PID.
    • If PID value is unstable, check for poor connection.
    Fig 1: Inspecting Sensor Connectors Or Wires
    G03637627Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals