Service Cautions: Reassembly

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.

Fig 1: Checking Torques Standard Values Of Parts
Courtesy of MAZDA MOTORS CORP.
If removed, these parts should be replaced with new ones:
- Oil seals
- Gaskets
- O-rings
- Lockwashers
- Cotter pins
- Nylon nuts
Depending on location:
- Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
- Oil should be applied to the moving components of parts.
- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.
Fig 2: Applying Sealant On Gaskets
Courtesy of MAZDA MOTORS CORP.