Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2005 >> 6 i, 4D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System (AJ)) >> Pcm Removal/Installation

Pcm Removal/Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • To replace the PCM, connect the WDS and perform the PCM configuration. (See PCM REPLACEMENT .)
  1. Disconnect the negative battery cable.
  2. Remove in the order indicated in the table.
    Fig 1: Removing PCM (Torque Specs)
    G03644196Courtesy of MAZDA MOTORS CORP.
  3. Install in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals