Service Specifications

A/C SYSTEM SPECIFICATIONS

Application

Specification

Compressor Type

FS-10 Swashplate, 5 Double-Acting Pistons

Compressor Belt Deflection

⁽¹⁾

Compressor Magnetic Clutch Air Gap

0.014-0.029" (0.35-0.75 mm)

Compressor Oil Capacity

⁽²⁾

Cycling Switch

Open

22-28 psi (152-193 kPa)

40-47 psi (276-324 kPa)

Magnetic Clutch Gap

0.014-0.029" (0.35-0.75 mm)

Pressure Relief Valve

550 psi (3792 kPa) Minimum

Refrigerant (R-134a) Capacity

33.75 ozs.

System Oil Capacity

6.29-7.71 ozs.

System Operating Pressures ⁽³⁾

High Side

126-230 psi (869-1586 kPa)

Low Side

25-45 psi (172-310 kPa)

⁽¹⁾	Serpentine belt tension is maintained automatically by a spring-tensioned idler pulley. No adjustment is necessary.

⁽²⁾

If replacing the compressor, measure the amount of oil drained from the old A/C compressor, pour the same amount plus 0.5 ounce (15 ml) of clean ND-OIL8 compressor oil into the new A/C compressor. If replacing the condenser, measure the amount of oil drained from the old A/C condenser, pour the same amount plus 1.4 ounce (40 ml) of clean ND-OIL8 compressor oil into the new A/C condenser. If replacing the front evaporator, measure the amount of oil drained from the old A/C evaporator, pour the same amount plus 1.4 ounce (40 ml) of clean ND-OIL8 compressor oil into the new A/C evaporator. If replacing the rear evaporator, measure the amount of oil drained from the old A/C evaporator, pour the same amount plus 1.4 ounce (40 ml) of clean ND-OIL8 compressor oil into the new A/C evaporator.

⁽³⁾	Specification is with ambient temperature at 80°F (27°C) and engine speed at 1500 RPM.