Selector Lever Component Inspection

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable.
Remove the center console.
Remove the dashboard completely.
(See DASHBOARD REMOVAL/INSTALLATION .)
Disconnect the selector lever component connector.
Inspect for continuity at the selector lever component.
- If not as specified, adjust the selector cable.
  See SELECTOR CABLE ADJUSTMENT .
Fig 1: Selector Lever Connector Terminal Continuity Inspection Table
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying Terminals Of Selector Lever Connector
Courtesy of MAZDA MOTORS CORP.