Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2003 >> Tribute ES, FWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Control System (HVAC) >> Function Selector Switch >> Removal and Installation

Removal and Installation

  1. Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT CLUSTER FINISH PANEL .
    Fig 1: Removing Function Selector Switch
    G01902589Courtesy of MAZDA MOTORS CORP.
  2. Remove the function selector switch knob.
    Fig 2: Removing Function Selector Switch
    G01902590Courtesy of MAZDA MOTORS CORP.
  3. Remove the function selector switch.
    1. Push in the locking tab on one side of the function selector switch.
    NOTE:
    • Align the function selector switch locking tabs with the holes in the housing and press the function selector into the housing. Verify that both locking tabs are secured.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals