Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2003 >> Protege5 Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> On-Board Diagnostic [Cruise Control System] >> Inspection Of DTCS For Condition Detection Mode >> Using The Cruise Set Indicator Light

Using The Cruise Set Indicator Light

NOTE:
  • If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruise set indicator light will not give a correct indication when you inspect the system. Use the USING THE SST (WDS OR EQUIVALENT)  (WDS or equivalent) to determine the cause of the malfunction.
  1. Drive the vehicle at over 16 km/h {10 mph}  .
  2. Operate each of the cruise control switches.
  3. Stop the vehicle and let it idle.
  4. The following steps to activate the detection mode.
    1. Turn on the cruise control main switch.
    2. Push up the cruise control switch and hold it in the RESUME/ACCEL position for at least 3 seconds  . (The cruise set indicator light will illuminate for 3 seconds  .)
      • If a DTC is indicated, inspect the corresponding system area.
  5. The condition detection mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.
    Fig 1: Identifying Cruise Control Switch
    G03590771Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals