Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2000 >> MPV ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 380 (Engine Control System (AJ)) >> Clutch Pedal Position (CPP) Switch Inspection >> Continuity Inspection >> Notes

Continuity Inspection: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the clutch switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
  3. Inspect for continuity between the clutch switch terminals B and D using an ohmmeter.
    • If the clutch switch is okay, but the PID value is out of specification, perform the "Circuit Open/Short Inspection".
    • If not as specified, replace the clutch switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
      Fig 1: Identifying Clutch Switch Connector Terminals
      G03644218Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals