Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2000 >> MPV ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Symptom Troubleshooting (Engine Control System AJ)) >> Engine Control System Operation Inspection >> EVAP system leak inspection using WDS or equivalent >> Evaporative system test procedure >> Notes

Evaporative system test procedure: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select the EVAP system test from the Toolbox on the WDS display and follow the instructions.
  2. Verify that all of the following PIDs are within the specifications at the pre-test confirmation screen.
    NOTE:
    • To successfully perform this procedure, all PIDs must be within the following specifications before proceeding to the next step.
    • The PCM will cancel the EVAP system test if the B+PID value falls lower than 11.0 V  during the test.
scientia non olet · About Mike's Workshop Manuals