Continuity Inspection

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the column cover.
Disconnect the connector.
Inspect the continuity.
- If not as specified, replace selector lever. (See SELECTOR LEVER REMOVAL/INSTALLATION .)
  
  Fig 1: P Position Switch Continuity Specifications
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Identifying P Position Switch Side Connector Terminals
  Courtesy of MAZDA MOTORS CORP.
Connect the connector.
Install the column cover.
Connect the negative battery cable.