Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2000 >> MPV DX >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (On-Board Diagnostic [Engine Control System L3)) >> On-Board Diagnostic Test >> On-Board System Readiness Tests Access Procedure

On-Board System Readiness Tests Access Procedure

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the necessary vehicle preparation and visual inspection.
  2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located at the left side of the center console.
  3. Monitor the OBD-II systems operating status by WDS or equivalent. See Figure
scientia non olet · About Mike's Workshop Manuals