Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2000 >> B3000 TL, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> System Tests >> Test L: Cruise Control Indicator Does Not Turn Off

Test L: Cruise Control Indicator Does Not Turn Off

  1. Turn ignition switch to LOCK position. Disconnect cruise control servo harness connector. Turn ignition switch to RUN position. If cruise control indicator illuminates, go to next step. If cruise control indicator does not illuminate, replace cruise control servo and perform SELF-DIAGNOSTIC TEST  under SELF-DIAGNOSTIC SYSTEM.
  2. Turn ignition switch to LOCK position. Disconnect instrument cluster 16-pin harness connector C-214 (located behind instrument cluster). Measure resistance between ground and terminal No. 1 (Orange/Light Blue wire) at cruise control servo harness connector. See Figure . If resistance is greater than 10 k/ohms, replace instrument cluster printed circuit. If resistance is 10 k/ohms or less, repair short to ground in Orange/Light Blue wire between instrument cluster and cruise control servo. After repair, perform SELF-DIAGNOSTIC TEST  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About Mike's Workshop Manuals